Where is the P0715 sensor located?

Answer 1

The code is for the turbine speed sensor. The part is in the middle of the transmission. You would need to remove the trans and take it a bit more than half way apart. This being the case, make darn sure the sensor is the problem. The sensor itself was a very durable part. The failure rate is very low. I do not know all the symptoms that go with the code. If the van will not move the most probable cause is the input shaft seized in the center support. This will cause the code. If the van moves but sets this code I would check wiring from outside of trans back to the computer. Hope this is helpful......