Crankcases and PCV Valves
Chevy S-10
Nissan Trucks and SUVs
Ford F-250

Where is the PCV valve located in a 1997 Nissan truck?

313233

Top Answer
User Avatar
Wiki User
Answered
2006-05-22 22:15:20
2006-05-22 22:15:20

It is right behind the altenator. You can barley see it but it's there, you probaly have to feel for it.

012
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


The EGR valve in a 1997 Nissan Altima is located at the top of the motor in a position near the firewall. The EGR valve is held in place by a vacuum line and 2 nuts.


The 1997 Nissan truck does not have a Twin Cam. It is a 2.4 sohc 4-cyl.


"How much is the cost of the Catalytic converter on a 1997 Nissan truck?"


it's between the oil filter and the alternator


I'm no sure I was wondering the same thing...........



I have a 1997 Nissan 2wd pickup with an automatic transmission and 4 cylinder. The thermostat is located on the lower radiator hose under the power steering pump.


On the 1997 Nissan pickup its just above the oil filter, lower right of engine, access through right front wheelwell after removing wheel, it's a screw in affair.


where is the transmission censor located on a 1997 Chevy cheyenne truck


The purge control valve is located behind the rear wheel that is on the same side as the gas tank. By simplysliding under the bumper one can view the canister and the valve.


on the right hand inner fender you will see a long block of 4 or 5 fuses


A 1997 Dodge Dakota does not have an EGR Valve.


The PCV valve is located on top of the valve cover in the middle.


Where can I locate the fuel filter on a 1997 Nissan Pathfinder?


Nissan will adjust your valves for 75.00,just call them.


When owning a car, a person should know the gas tank size of the car. The 1997 Nissan truck has a gas tank size of 15.9 gallons.


The 2.4 liter 4 cylinder in a 1997 Nissan Pickup has a timing CHAIN


It is located in or on the transmission.


In a 1997 Nissan Altima, the transmission dipstick is located next to the motor. The dipstick has a red handle to pull out.


oilk sending unit on nissan 200sx located


where is the heater control valve for a 1997 ford expedition


They are identical except for the 92 uses OBD1 and the 9+ use OBD2 (few more sensors).



up my butt. It's the evap sensor and it is located at the back axle near the fuel tank.


The 1997 Chevrolet blazer modulator valve is located on the firewall in the engine compartment. The valve will be on the passenger side of the firewall.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.