Not sure about the 1989, but 1990-1993 it goes into the valve cover. Look for a hose running to the valve cover and the PCV valve should be what is at the end of it pushed into the valve cover.
The flasher for the 1989 Honda accord is located above the steering column. To activate it shift it to the right.
It is important to know the location of the car parts in a car. The horn of a 1989 Honda Accord is located behind the steering wheel.?æ
The temperature gauge sending unit, located on a 1989 Honda Accord LXI is located on the thermostat. It is the small connection with a single wire sticking out of it.
A 1989 Honda Accord has a timing belt.
The PCV valve is located in the camshaft cover,in the crankcase breather chamber or in the hose which connects the crankcase breather chamber to the intake manifold
The valve cover torque specs for a 1989 Honda Accord is between 20 and 25 pounds per square inch. Proper torque is important to keep the cover in place without causing damage or leaks.
There was not a 1999 Honda Accord LXi made. Do you have a 1989 Honda Accord LXi?
NOPE, THEY ARE TOTALLY DIFFERENT.
The antenna motor is located behind the driver side kick panel.
How to change the alternator in a 1989 Honda accord lx
The horn fuse on a 1989 Honda is located in the engine compartment fuse box. The fuse in the engine compartment is in slot 4 and is also used for the brake lights.
No, Not without customization.
What is your question? You have not asked a question or provided enough information for an answer to be given. The 1989 Honda Accord contains no Freon. It contains R134a refrigerant.
The 1989 Accord had 120 H.P. The carbureted engine has 98 h.p. while the lx-i has 120.
A 1989 Accord Lxi fuel pump can be reached vial the service panel located under the rear seat. Remove the seats and panel to reach the pump.
There are several things that can cause your 1989 Honda Accord to stall on acceleration. The most common cause is a plugged or dirty air filter.
It is located inside the fuel tank. You can access it from the top through an access hole. No need to remove the tank.
i wouldn't do it, it can be done with alot of money and time and modifications, but not worth it.
At the engime end of the upper rad hose. Make sure the spring goes toward the engine.
Propping the hood of a 1989 Honda Accord will allow driver to see the whole engine bay. The transmission is on the left and sticking upwards from it's housing will be the dipstick.
those years it was either or. what is the letters after the car usual si means injected. hope that helps. I have a 1989 Honda Accord LXI it is fuel injected
I am trying to find out the same thing myself. A couple of people have told me from $200-$300.
it is located just below the passenger side front motor mount, when looking down at the motor.
The bottom of the oil pan.