All GEN III GM egines (5.3L,6.0L,8.1L and LS1)have an internal PCV You do NOT change them....... well like most truck they are locted on top or back beside the maifold it will have a hose that goes to it one the passinger side at the top of the motor I am not positive, but I do not think it has a PCV valve. The Positive Crankcase Ventilation (PCV) valve on the 2002 Chevy Suburban with the 5.3 liter engine is located at the rear of the left valve cover-pull it out and check for vacuum with you finger.
The PCV valve on a 2002 Chevy Suburban 6.0 liter engine is located in the engine. You cannot miss the valve.
That is a 350 engine.
That is a 350 engine.
It is pushed in the top rear drivers side valve cover and has a vacuum hose hooked to it.
Where is the fuel pressure regulator located on a 1989 chevy silvarado with 5.7 liter engine
a long time
where is the oil filter located on a 2009 chevy malibu?
The 1999 Chevrolet Suburban 1500 5.7 liter V-8 air check valve can be found on the firewall in the engine compartment. The air check valve will be on the drivers side of the firewall.
THE TIMING IS COMPUTER CONTROLLED. It requires an engine scanner to set the timing on that engine.
It is a 5.3 liter 1995 chevy suburban
Under hood, center, rear engine area, end of intake manifold, mounted in block.
By that time Chevy was pretty much using electric pumps that are located in the tank, itself.
in the engine block
It is built into the alternator.
The thermostat is located in the housing at the engine end of the top radiator hose.
The engine block coolant drain plug on 4.3 liter Chevy Blazer is located on the bottom of the engine, near the oil filter. It allows coolant to be completely drained from the block during maintenance.
The cylinder order on the Chevrolet 5.3 liter engine, in your 2007 suburban, is one, eight, two, seven, three, six, four, five. The firing order can be found in your owners manual.
There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.
The oil pressure sending unit, on a Chevrolet 4.3 liter V-6 engine, is located on the left side of the engine, just above the oil pan. The sensor is near the front of the engine.
The pcv is located on either valve cover or the intake.
You can not use a timing light to set the timing on that year engine. The timing is computer controlled and it requires a engine scanner to set the timing.
The transmission has to be removed. Once the trnsmission is removed the fly-wheel is right there to be removed.
It is in the gas tank.