answersLogoWhite

0


Best Answer

On a 1993 Buick Regal 3.1L, the PCV valve is located on the intake manifold. It is situated underneath the MAP sensor.

User Avatar

Wiki User

โˆ™ 2014-10-07 01:59:52
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the PCV valve on a 1993 Buick Regal 3.1L?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Have a 1991 buick regal custom 31L sometimes it will just up and die while driving but will start again doesn't do it all the time any clue why?

I have the same issue it is the map sensor


What is 31L in milliliter?

That is 31,000 ml


What is 31 liters as decilieters?

31L is 310 deciliters.


Where is the crank sensor on a 1991 Buick Regal - 31L?

THE CRANK SENSOR IS LOCATED ON THE PASSINGER SIDE OF THE ENGINE , BUT ON THE BACK OF THE ENGINE YOU MMUST REMOVE THE FRONT TIRE TO REACH IT RIGHT BEYOND THE SPEED SENSOR No it's not! It is located between the transmission and the engine block above the oil pan on the rear(since the engine is sideways)just about the middle of the car. It has one bolt holding it in and it is a little hard to get out, careful not to break the bolt


How much is a Remington 31l worth?

depends on the age and quality


What is the horsepower on a 94 Pontiac grand am gt 31L SFI V6?

160


What is the oil capcity for a 2000 4 dr Grand Prix 31L?

5 liters


What is the push-rod order for a 31L engine in a 1996 Chevy Lumina?

What_is_the_push-rod_placement_for_a_1996_lumina_3.1_engine


What is the approximate rate of water transport in the specimen?

hahaha.... bleeh bio 31L bro?


Where is the PCV valve located on a 1992 Chev Cavalier Z24 31L?

The PCV valve is located on the back valve cover by the firewall, you will need to remove the strut brace to get at it. The hose runs from the valve to the rear of the intake plenum and it is very stiff, follow it down to the valve cover and pull straight up. It is very difficult to remove due to the lack of room and the fact that the hose is not flexible. if the hose is stiff replace it that's is from the motor runing at 220 degrees all the hoses go bad quick when they run that hot


Where is the radiator fan switch on an 1995 olds cutlass 31L?

http://wiki.answers.com/Q/Where_is_the_radiator_fan_switch_on_an_1995_olds_cutlass_31L"


Where is the oil drain plug located on a 1995 Chevy Corsica 31L 6-cylinder engine?

On the bottom of the motor.

People also asked