On transmission by where one of the axles attaches to it.
My Haines book says it's on top of the trans mission just under the mass air flow sensor. You have to remove the ducting & M.A.F.Sensor to get to the speed sensor but removing the speed sensor looks tricky.
It unscrews just like a spark plug.
IT should be in the air duct going to the throttle bore.
heater will not blow on a 1996 ford contour
Looking in from the drivers-side wheel well, you can see a sensor with a 2 wire connector on the very end of the trans - that one is the turbine speed sensor (TSS). On a related note, the vehicle speed sensor (VSS) is over to the right, kinda facing the firewall.
how to remove the vent from dashboard of 1996 ford contour
on the front of the engine. it has a white wire on it and it screws in and out like a spark plug
How do you add freon to a 96 Ford Contour
the speed sensor is located on the front of your rear end. it is held in by one bolt.
This engine has no turbine or turbo. Although the 1996 Ford Ranger does not have a turbine or turbo, it does have a turbine shaft speed (TSS) sensor. It is located inside the automatic transmission.
it is located where the transmission is and is very easy to change. on a 2000 ford contour that is.
No. The Contour is a front-wheel drive car, and the Ranger is rear wheel drive.
You will see it if you look directly at the front of the motor. It will have a thick white wire and is screwed in the motor.