0
Just follow the top radiator hose to were it clamps onto the engine, That will be the thernostat housing, just remove that housing and it will be right there. You will need to drain engine coolant first. MAKE SURE ENGINE IS COLD. That is if the engine is a 5.7L 350.
If it is something other then a 5.7L 350. Then the thermostat will be were the lower radiator hose clamps onto the engine, That will be the thermostat housing, remove it.
If it is a V6 engine then it will be at the end of the top hose, just like the 350 engine.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the knock sensor on a 99 silverado 4.3l?
where is knock sensor located on a 99 Silverado 1500 4.3
Where is the Coolant sensor on a 2005 Silverado 1500?
It is on the intake manifold near the thermostat housing.
How do you install a thermostat on a 2001 Chevy Silverado 1500 5.3 Liter?
you blow it up
Can you interchange interior from a 2003 silverado 2500 hd with a 1999 silverado 1500?
classic '99? If not then yes, most I think.
Lug nut torque setting 2006 silverado 1500?
sliverado 1500 99-05 torque setting is 140 ft-lbs
How do you change the thermostat on a 2002 silverado 1500 HD?
Again, not a professional car (hearse or ambulance ) question and I am not a mechanic
What way does the thermostat go in on a 1994 Chevy silverado 1500 5-7L.?
The spring goes down in the engine
What is the towing capacity of a 99 Chevy silverado 1500 wthe 4.3 V6 2wd?
The maximum towing capacity of this 1999 Chevrolet Silverado 1500 is 5,000 pounds. However, a limit of 3,500 pounds is recommended.
Where is the starter relay switch located on a 1999 Silverado 1500 4.8?
The starter relay on that 99 Silverado is located in the under hood power distribution center.
Where is the thermostat on a 2000 Chevy Silverado 1500 5.3 engine?
follow the upper radiator hose it would be right at the end of that
Are 1990 to1998 Chevy Silverado 1500 hoods the same?
Yes, From 88 to early month of 99 will interchange.
Where is the thermostat located on a 99 dodge ram 1500?
follow the top radiater hose to the engine should be two bolts and the thermostat valve should be behind that
