Pretty sure that it is mounted on the side of distributor. The wireing harness plugs directly into it. The thick film module (TFI) is held on with two screws. There are a couple types of screws in use. One of them uses a torx wrench. The other which is more common and likely the one that you have, uses a 5.5 mm socket. There probably isn't much room to get in there. If neccessary, the parts stores sell a special wrench to accomadate the tight area. Happy wrenching.
The engine computer is the ignition module.
The engine computer is the ignition module.
Passenger side of the firewall, the engine computer is the ignition module.Passenger side of the firewall, the engine computer is the ignition module.
The engine computer is also the ignition module.
The engine computer, next to the battery, is the ignition module.
The 1990 Chevy Celebrity engine is distributorless, the ignition is handled by a combination of the engine control module(computer) and the ignition control module. You did not mention which engine the car has. If your car has the 4 cylinder engine the ignition control module is below the intake manifold at the rear of the engine. You can follow the spark plug wires to it. The coils are mounted to the ignition control module. If your car has the V6 the ignition control module is near the starter and again you can follow the spark plug wires to it. Again the coils are mounted to the ignition control module.
The engine computer is the ignition module. It is the large black box under the hood.The engine computer is the ignition module. It is the large black box under the hood.
The engine computer (behind the battery) is the ignition module.
were is ignition drive module located in the engine
On 98-03, it is integrated with the cam position sensor inside the nose cone on the right hand side of the engine.
The 1993 Hyundai ignition module is located on the firewall in the engine compartment. The ignition module will be on the drivers side of the firewall.
The ignition control module is located under the electronic ignition control module cover. On a 1997 2.4L cavalier, it will have the words 2.4L twin cam stamped on it. It is on the top of the engine and is held in place with four bolts. This cover must be removed to get to the spark plugs.