0
The alternator is mounted low on the back side of the engine.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is the brake light switch located on a 1994 mercury villager?
On the brake pedal assembly.
Where is the neutral safety switch on a 1994 Mercury Villager located?
It might be the transmission range selector
Where is the theromstat located on a 1994 Mercury Villager?
Should be in a removable housing at the engine end of the upper radiator hose
Where is the blower motor resistor pack located on a 1994 mercury villager?
On the bottom of the heater/AC housing under the dash.
How do you change a fuel pump on a 1994 mercury villager?
The fuel pump is located in the tank, and the tank must be removed to access it.
What is the pressure on the radiator cap for a 1994 Mercury Villager?
According to one of Fords websites : For a 1994 Mercury Villager , 3.0 liter V6 : The radiator cap is ( 13 PSI )
How do you to reset gps for 1994 mercury villager?
A Villager is not equipped with any kind of GPS device.
How do you replace the alternator on a 1994 Mercury Villager?
the alternator is removed from below and there is three bolts (10 mm socket) that need removed. one of these bolts is on the other side of alternator. use a small mirror to see this bolt. Don't forget to disconnect battery!!!
How do I get the transmission on a 1994 Mercury Villager Van out of fail safety mode?
Replace the transmission computer. Located under the center console.
How many cylinders is a 94 mercury villager?
The 1994 Mercury Villager has a 3.0 litre V6 engine from the factory : ( it has 6 engine cylinders )
What is the spark plug gapping on a 1994 Mercury Villager?
According to one of Fords websites : For the 3.0 litre V6 engine in a 1994 Mercury Villager : ( the spark plugs are gapped at .032 inch )
Where is the ignition control module located on a 1994 Mercury Villager?
The ignition module and coil are contained inside the distributor and are not serviced as separate parts.
