0
The 1994 Mercury Villager has a 3.0 litre V6 engine from the factory :
( it has 6 engine cylinders )
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you know when valve lifter for 94 mercury villager r bad?
how do you know when valve lifters for 94 mercury villager 3.0 engine r bad
Is a PCV valve expensive for a mercury villager 94?
No, it's not.
Does the 94 villager has timing belt or chain?
The 3.0 litre V6 engine in a 1994 Mercury Villager has a timing BELT
What are the three fuel lines on the 94 mercury villager for?
supply, return, and vapor collection.
How do you remove the brake caliper on a 94 mercury villager?
Remove the two slider screws that hold it in place.
Your 94 mercury villager stalls when slowing down idle low below 800rpm?
vacuumm leak
How do you remove back seat in 94 mercury villager?
You remove the center seat and slide the back one up into it's place.
Where is the factory amp in a 94 Mercury Villager?
hidden back drivers side storage compartment, passengerside should have your Jack etc.
How do you replace the outer axle boot on 94 mercury villager?
It's easier and more economical to replace the axle assembly with a rebuilt one.
Is it safe to remove the ac compressor belt on a 95 mercury villager - What else does this belt turn?
shouldn't run anything else, my 94 doesnt.
Where is the obdII scanner plug in on a 94 mercury villager?
Stop looking. It doesn't have one. Villagers did not have OBDII (with data plug access) until 1996.
Where are the inner tie rod bushings located on a 94 mercury villager?
The inner tie rod bushings are in the steering rack assembly and can not be service without removing and rebuilding the steering rack.
