answersLogoWhite

0


Best Answer

See where the coolant overflow tank is on the firewall? Now look to the passenger side and down. It is kinda hard to see cause there is a bracket over it. The adjustment bolt is through the bracket on the firewall side. It sucks to change this belt.

User Avatar

Wiki User

โˆ™ 2004-11-11 23:47:43
This answer is:
User Avatar
Study guides

Add your answer:

Earn +20 pts
Q: Where is the alternator located on a 1996 Dodge Neon?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What and where is the tranny on a 1996 dodge neon?

the transaxle is located to the right, slightly below and attached to the engine on a dodge neon


How do you tell if your alternator is bad in your 1996 dodge neon?

you could pull off your positive battery cable if it stalls out then you alternator is the problem


Where is the ignition control module located on a 1996 dodge neon?

Autozone


How do you replace power steering belt on 1996 dodge neon?

Since There is no tensioner pulley you have to loosen your alternator.


Where is the fuel pump located on a 1996 dodge neon?

It is inside the fuel tank.


Where is the crankshaft sensor on a 1999 Dodge Neon located?

I believe it is located on the block right above the oil filter housing. That is where it is on my 1996 neon.


Can a dodge neon alternator fit on a Pontiac?

No it will not fit.


Where is the voltage regulator located on a 1998 Dodge Neon?

its built into the alternator,cheaper to buy new or rebuilt alternator The engine computer is the voltage regulator.


Will a 1996 dodge caravan take a 1996 dodge neon transmission?

No.


Where is the distributor for a 96 dodge neon located on the car?

A Dodge Neon does not have a distributor.A Dodge Neon does not have a distributor.


Does the 1996 dodge neon have a catalytic converter and where is it located?

Yes. It is located under the car, about middle point of car.


Is an alternator for a 1996 dodge neon interchangeable with a 1995 dodge neon?

It will fit physically but the plugs may be different. If you are buying this from a junk yard or from a junk car just get the plugs from the parts vehicle and solder them on your harness.

People also asked