I don't know if it's the same as the Ford Mustangs , but the BAP sensor was mounted on the firewall
On the 4.0 SOHC V6 it is located on the left valve cover near the engine oil filler cap. On the 4.0L pushrod it is located at the rear of the engine block.
where is fuel rail pressure sensor on 2000 ford explorer 4.0 located?
The 1991 Ford Explorer 4.0 engine does not use a cam sensor, but rather a crank sensor at the lower front of the engine to set crank or time position, two bolts and one connector.....
The Mass Air Flow sensor is located on top of the air filter housing on Ford Explorer.
The 1998 Ford Explorer 5.0 liter engine IAT sensor is located between the engine and the air filter box. The IAT sensor will be on the air intake hose.
I drive a 1995 Ford Explorer and as far as I know it doesn't have a knock sensor My Haynes repair manual engine wiring schematic shows a knock sensor on the 1996 Ford Explorer - OBD II / EEC V system
the crankshaft sensor is located behind the crank pulley. the bottom pulley
The turbine shaft speed (TSS) sensor is located inside the automatic transmission.
Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )
it is located on the pedal, look on the pedal you will see a black sensor with connector plug. this is it
i don't know the answer
there are several sensor, you can go to autozone.com and find out where they are