Its located under the hood in the right hand cowl behind the windshield washer bottle.........
Well I Know you must remove the glovebox and ashtray assembly and then you can see the housing but that's as far as I got.
what is a controller in 2.5 motor in a dodge
what size motor? 3.3?
Blown fuse, defective blower motor, defective wiring, defective blower motor resistor pack, or in rare instances a defective blower motor speed control.
it is located on the fire wall on the passenger sideround looking object
check coolant level
check the blower motor resistor located on fire wall behind washer fluid tank
it's the blower motor
Dodge Dynastys dont have Fan Belts... Their fans run on an electric motor.
Open the bonnet, remove the scuttle cover, wiper motor, and finally blower motor.
The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.
faulty blower module. Under hood not far from blower motor
The heater blower motor can be found beneath the passenger side dashboard. Remove the wiring harness from the back of the blower motor. Remove the blower motor retaining bolts. Reverse the process to install your new blower motor.
The 1991 Honda accord blower motor resistor is located on the firewall in the engine compartment. The blower motor resistor will be on the passenger side of the firewall.
I believe its 6"
a diagram for a 1991 dodge dynasty w a 6 cylinder 3point 3 liter engine
Behind the power steering pump on the passenger side.The pump will have to be removed in order to remove the blower motor.
Many are in the air duct near the blower motor.
The 1991 Dodge Dynasty starter relay switch can be found in the fuse box. The starter relay switch will be in the third column, third from the top.
your blower motor has gone bad In the firewall on the passenger side of the truck is the blower motor speed resister coils, they burn out alot. I could not find one for my Dakota so I got one from a dodge caravan and I changed the wirring, that is the most likely problem
A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.