0
2 8mm screws hold it into the front of the plastic box under the hood next to the A/C condensor on the passender side near the firewall
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the blower motor resistor on your 2008 F350 super duty?
Behind the glove box.
Why does the heater blower motor not work on the low speed on a 2002 F350 super duty?
bad blower resistor
Where is the blower motor resistor located on a 1999 Ford F350?
firewall, passenger side, right behind the a/c receiver dryer. it is secured by two small screws. has four or five wires going into it. hope this helps..
Why does a Ford F-350 blower motor occasionally not run?
The blower motor on a Ford F350 may occasionally not run due to a loose wire or faulty connection. This can often be corrected by re-seating the connection.
Where is the blower motor relay located for a 1994 Ford F-350 truck?
I have a 92 f350 4x4 crew cab and the relay is located on the back of the blower motor located in the engine compartment. comes off with 2 screws. If your fan is going it will burn out the relay as soon as you install the mew one. Speaking from experience.
2004 F350 crew cab super duty with a V10 and the heat and air blower works only on high speed I have replaced the fan switch but it didn't help What else could it be?
the resistor bank for the fan is blown replace it it is mounted in the air duct after the fan
What size of diesel motor dose your 2008 F350?
6.7
Where can you find frame side motor mounts for a 1978 f350?
i need m0unts for a 78 f350 with a 300 ci in line 6
Where is the fuel filter on a 2004 Ford F350 Diesel Motor?
on the top of motor round black housing
How much weight can a 2000 F350 7.3 liter diesel pull?
How much can 2000 f350 diesel pull will it handle pulling a 1991 sea ray 280DA @8k
How do you remove a heater core from a 2002 F-350 Ford truck?
how do I change the heater blower on a f350 2002
What could be causing a 2000 F350 Ford diesel oil leak?
The high pressure oil lines on top of the motor under the fuel and water separator are rubbing together and causing holes
