The BCM is located on the back of the fuse panel located inside of the cab, directly in front of the driver's left knee. There is a gray panel under the steering column. Remove this with a flat head screw driver (4 Twist Spring Screws). To remove the BCM, you will need to remove (2) 10mm bolts at the top of the fuse panel and (2) 10mm nuts at the bottom. Once removed the panel can be manipulated sideways, where you will have access to a gray plug on the side of the BCM. Remove this. Turn the panel again and you will see 2 connectors at the back of the fuse panel, that at first appear to be one in the back of the panel. (2) 10mm bolts hold them in as well. Remove (Bolts stay inside of housing) and pull harnesses away. Now the fuse panel and BCM can be taken out of the vehicle. Be careful when pulling out that you don't break every fuse on the metal support.
controls all of the electrical systems not related to the motor
You need to specify which module.
I have a erorr code P0603 and P1211 and it said Powertrain Control, Keep alive memory Erorre Can you help me?
Short in the circuit, the circuit is overloaded, or you are installing too small a fuse.
driver side valve cover between coolant jug and turbo.
glow plug control module
it is located above the heater core trap door behine the glove box.
Normally attached to the distributor (not the cap) on the side. Takes a special tool to remove it. Available at the parts store.
don't know about the particular year. on my 95 F250, the ICM is located on the driver's inside fenderwell, underneath the Powertrain Control Module. hope that helps.
Behind your emergency brake release handle
Xtreme 4x4 - 2001 Skyjacker F250 Project was released on: USA: July 2006
There is no such thing as a 2001 f250 351 Windsor. I believe the last year of the 351 overhead valve motor was 1996.