Chevy Lumina

Where is the cam sensor on a 1996 Chevy Lumina?

234

Top Answer
User Avatar
Wiki User
Answered
2009-07-05 20:51:23
2009-07-05 20:51:23

under neath the power stearing pump.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


It's in the dist. The dist. itself is the cam sensor.


Assuming that it is a 3.1 V6, as most of them are, there is no cam sensor. Only a crankshaft sensor. It is located behind the harmonic balancer. To replace it the balancer has to be removed.


There is no cam sensor on a 93 3.1. Just a crankshaft sensor....which is located behind the harmonic balancer. WRONG! it does in Fact have a cam position sensor! its underneath the intake plenum!


There is no cam sensor on a 90 3.1. Only a crank sensor.


The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.


the timing marks are not on crankgear on cam gear Chevy Lumina 3.1 1995 would it be keyway to keyway


That year did not have a cam sensor.


That year did not have a CAM SENSOR.


1992 Chevy trucks did not have a CAM SENSOR. They had a distributor.




I had to go to a dealership in order to find the location of the cam position sensor on a 1993 / 3.1 chevy lumina. I could order the part but was unable to find the location. after returning from the dealership. I am here to discredit those who say it doesn't have one. it in FACT does have one!. It is located under neath the intake plenum..


There is no "oil cam sensor". There is a oil pressure sensor and a cam sensor, but they are two different sensors.



The cam sensor is inside the distributor.The cam sensor is inside the distributor.


The cam sensor is mounted into the front timing cover just behind or near the water pump. Note that failure of the cam sensor to work properly is usually not cause by a faulty cam sensor but more commonly a failed permanent magnet located in the cam drive gear.



1999 Chevy what? What kind of 1999 Chevy. different models have different sensor positions


That engine does not have a cam sensor. It still has a distributor. If the engine is not firing then I would replace the ignition module that's in the distributor under the cap.


It is the only electronic device that's in the distributor underneith the rotor button.


That is the only electronic device that's in the distributor under the rotor button.


The cam sensor is located on the left side of the engine (as your looking at it) on the valve cover


No it does not. It has a distributor no need for a cam sensor.



It has both, The crank sensor is on the timing cover passenger side behind the balancer. The cam sensor is the distributor, Inside of it.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.