0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
95 Chrysler cirrus V6 won't start where is the cam sensor?
It is a non serviceable part of the distributor. The distributor will need replaced if the cam sensor has failed.
What does a diagnostic code P0122 mean on a Chrysler Town and Country?
i just got that code on my 95 Chrysler lhs, and it means the throttle position sensor (tps) is bad or the wiring to it.
Does a 95' eclipse have a cam senor?
yes it dose, it has a cam sensor and a crank sensor,
Does a Chevrolet 2.2 have a cam position sensor?
The 94 and 95 are the same,no cam sensor.1996 and 1997 are differant in one way.The 1996 and 1997 have a cam sensor. .The 97 has a cam sensor and the 94 does not.The 1996 has a cam sensor too.
What type of plug does the obd system have on a 95 Chrysler LHS?
six pin square plug under the dash on the driver side.
Where is the cam sensor and crank angle sensor in a 320i e36 95 model?
around the optical lens
Where is 1995 Concorde oxygen sensor?
The service department will put in a new oxygen sensor, with a 25% discount on parts if you are a Chrysler employee, for $102.**. The sensor, with the discout, is @ $95.
Where is the cam position sensor in a 95 ranger 4.0?
behind the intake manifold on the top surface of the cylinder block
Where is the Cam Sensor on a 1995 S10 blazer 6 cylinder?
The 95 S10 4.3L still uses the distributor.
Where are the two right o2 sensors located on my 95 Chrysler Concorde?
A 1995 Chrysler Concorde only has one oxygen sensor on each side. They are screwed into the exhaust manifolds.
Where is the maf sensor on a 2.5 cirrus?
From the information I have been able to gather, the 95 Chrysler cirrus do not have mass air flow sensor. Two different auto parts stores & 1 Chrysler dealer informed me that this particular vehicle does not have the sensor. Hope this helps, because I was looking for the same thing.
Where is cam position sensor location 95 eclipse?
On the drivers side of the valve cover...it's round and the plug for the harness points downwards.
