0
Where is the camshaft position sensor located on a 2001 Chrysler sebring 2.7L?
Wiki User
∙ 15y ago
For the 2.7l v6 engine, it is located on the left engine bank at the very front of the head. Look down at the front of the engine head, right under the top radiator hose and you will see a connector that is attached to the camshaft position sensor. It is held in place with a 13mm bolt. The top of the bolt has a wire loom cap on it that supports the wiring harness. Remove the plastic cap from the screw top and then remove the bolt with the 13mm wrench. After the bolt is removed, pull the sensor out. It is easier to remove the bolt by first removing the connector from the sensor.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Where is the camshaft located on a 2005 Chrysler Sebring?
The camshaft is in the cylinder head.
Is there a recall for the camshaft position sensor in a 1999 Chrysler Sebring coupe?
No.
Where is the camshaft position sensor located on a 1998 Chrysler sebring 2.5l?
it is an part of the distributor unit. you have to change out the entire distributor.
How do you adjust the camshaft position sensor in a Chrysler Sebring?
The cam sensor is not adjustable.
Where is the Camshaft position sensor on a Chrysler Sebring 2.5L?
It is built internal to the distributor.
Where is the camshaft position sensor on the 1999 Chrysler sebring 2.5L?
It is inside the distributor, serviced as part of the distributor.
Cost for replacing a camshaft sensor in a Chrysler sebring?
39.00
How many camshaft sensors are in a Chrysler Sebring convertible?
One
Does any one know the location of camshaft position sensor for a 1997 Chrysler sebring and how to install a new one?
it is at the rear of the cam on the driverside
Where is the camshaft positon sensor located on a 2005 Chrysler Sebring 2.4L sedan?
It is bolted to the driver side end of the cylinder head.
Where is the camshaft position sensor on a 1999 Chrysler Sebring?
On the six cylinder, it is inside the distributor. On the four cylinder, it is on the driver side end of the cylinder head.
Where is the camshaft position sensor on a 2000 Chrysler sebring?
On the four cylinder, it is on the driver side end of the cylinder head. On the six cylinder it is inside the distributor.
