0
Where is the camshaft position sensor on a 2000 Isuzu Amigo 4 cylinder?
Wiki User
∙ 18y ago
IAW the Mitchell shop manual, the CPS is located top front of the engine between the camshafts. The plastic covered wire going into the sparkplug cover probably goes to it. (may need to remove the top cam belt cover to see it---not real sure as I haven't been into it yet. As I understand, the CPS regulates the fuel to the engine. As I have one that is defective/dirty/out of adjustment, the tailpipe is sooty to the touch.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
P0342 camshaft position sensor circuit low input how can you fix on 1998 Isuzu amigo 4 cylinder and where is lacated?
How fixed camshaft sensor circuit low input
Where is the camshaft position sensor on a 1998 Isuzu amigo?
YOu need to remove the belt off the front of the engine, it is under the plastic cover in the top. It has three wires plugged into it. On mine one was black and blue, one was blue, and one was green. I found one at a wrecking yard.
How do you tell if a 1999 Isuzu amigo is a 4 or 6 cylinder?
Count the sparkplug wires.
What is the firing order for a 1994 Isuzu amigo 2 wheel drive. and which cylinder is the 1?
1 3 4 2 Number 1 Cylinder is the forward most cylinder.
How do you replace slave cylinder on a 1990 Isuzu amigo?
unbolt from trans.bolt on new one bleed system
Where is the coolant temperature sensor located on a 1998 Isuzu Amigo 2.2L engine?
The coolant temperature sensor is located under the hood of the car. The sensor is located to the left of the brake booster at the rear of the engine.Ê
How do you say your amigo in Spanish?
Tu amigo or su amigo
Where is the map sensor located on a 1989 through 2002 Isuzu Rodeo or Amigo?
On 89 thru 97 3.2L Passports, Rodeos, and Amigos the MAP or Manifold absolute pressure sensor is located on the right side of the intake manifold. On 98 and later it is on the right rear upper corner of the intake manifold, and on the 2.2L it is on the upper side of the intake manifold between the throttle body and the cylinder head
Where is the clutch slave cylinder on a 98 Isuzu Amigo located?
The clutch slave cylinder is attached to the middle of the transmission towards the passenger side. It is easy to see by looking under the car at the passenger side door.
How do you say your friend in spanish?
Amigo/a tuyo. Su amigo/a. Tu amigo/a
Is the Mexicans called amigo?
Mexicans are not called amigo because amigo is friend
What is the singular form of amigo?
Amigo is singular.
