There is one per cam, the sensor is bolted into the head by 1 bolt.
The camshaft position sensor on your 2002 automobile is located on the front of the camshaft. You will need to remove the front engine cover to access the sensor.
A bad camshaft position sensor will cause a engine to run very rough or not run at all. Replacing the camshaft sensor is very complicated.
You can check the Hyundai site... www.hmaservice.com... Sign up and there is a wealth of information on it. I just replaced my cam shaft position sensor on my 1999 Hyundai Sonata 4 cyl 2.4. It was a bolt and a clip. 2 minutes and done.. SONATA(EF) > 1999 > Engine > Engine ControlComponent Location Index > Camshaft Position Sensor (V6) > Camshaft Position Sensor (V6) >
The camshaft position sensor on a 4.3L engine would be in the distributor.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
The camshaft position sensor on a 4.6 liter engine is positioned on the side of the motor on the front of the cylinder head. A 4.6 liter engine has a camshaft position sensor on each cylinder head.
The camshaft position sensor, on a Ford 6.0 liter power stroke engine, is located inside of the rear engine cover. The sensor is on the back of the camshaft.
The Pontiac 2.2 liter engine camshaft position sensor can be found on the back of each cylinder head. The camshaft position sensor should be labeled as such.
A camshaft position sensor reads the location of the camshaft and sends that information the engine computer. This is needed for fuel and ignition timing.
IN YOUR ENGINE
The camshaft position sensor for the 3.0L V-6 engine is located in the distributor. Good Luck!
Replace the crankshaft and camshaft senors and then clear the codes with an oBD II engine scanner and that will fix it.