The 2003 Mazda camshaft position in sensor can be found on the back of the left-hand cylinder head. The camshaft position sensor should be labeled as such.
Camshaft position sensor of Mazda Milenia 2,5L DOHC is inside ignition distributor (the same part with iggnition comutator).
It's part of the distributor
It is located on the inside of the distributor . Three pin connector .
On a 1999-2005 model Mazda Miata the camshaft position sensor is located on the valve cover towards the rear of the engine (closest to the firewall). It has one 3-pin connector connected to it and one 10mm bolt to remove the sensor
Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
The camshaft position sensor on a Mazda Miata is changed by disconnecting the wiring harness and unscrewing the sensor using a wrench. The threads can then be cleaned and a new sensor torqued into place.
Most knock sensors are located in the block on the firewall side. Should be the only sensor with two wires in the block. It will also have a camshaft position sensor as well. Hope that helps. I am not educated on Mazda engines.
look under the alternator 1 inch and then to your right 2 inches. more or less.....
Where would the knock sensor be located on a 2004 mazda 6?
99 mazda b3000 where is the speed sensor located
Camshaft Position Sensor is on the back of the valve cover on the right side (if looking directly at the engine from the front of the car).