The camshaft position sensor on the 1999 4.0 L OHV engine is located at the rear of the engine block on the top of the engine where the distributor was installed on earlier versions of this engine. (according to my Haynes repair manual)
I'm not a mechanic / technician but from what I have read the camshaft position sensor for the Ford 4.0 liter EFI , V6 engine is on top of the engine , near the centerline , near the firewall ( apparently you can't see it until the upper intake manifold is removed )
Bank 2 is the drivers side of the engine in your Ford Explorer Sensor 2 is after the catalytic converter ( downstream )
ON FRONT OF RIGHT CYLINDER HEAD, NEAR BREAKOUT TO STARTER MOTOR.
The camshaft position sensor on a 2001 Dodge Ram 5.2 is inside the distributor, under the rotor.
Locate the camshaft sensor in your car. Disconnect the electrical plug on the sensor. Remove the bolt that holds it in place. Twist the the sensor to remove it and place in the new one.
its located in your MAF on the air intake ========================================================== The Mass Air Flow sensor is located between the engine air filter housing and the engine air intake tube on your 2004 Ford Explorer Sport Trac
Camshaft sensor is at the bottom front of the right side cylender head. It can easily be accessed by simply tugging on and removing the airbox.
Where is the cabin filter located on an Ford Explorer Sport Trac 2008?
Ford did not start using knock sensors on the Ford Explorer engines until 1996, when they switched to the EEC-V system.
The MAF sensor is always located in the ductwork between the air filter box and the throttle body.
It is not a simple sensor. It is a part of a pipe. Look for this part number: 9E616. It is located over the fuel tank.
The ABS Sensor is located inside of the hub, which is replacable only by replacing the entire hub assembly as a unit.
On your Ford Explorer Sport , 4.0 EFI : Bank 2 is the drivers side of the engine Sensor 1 would be close to the engine ( it might even be in the outlet of the exhaust manifold ) BEFORE the exhaust enters the catalytic converter
Its part of the MAF sensor. In 98 they integrated it.
Were is fuel injector located on a 1999 ford explorer
Bank 2 is the drivers side of the engine on your Ford Explorer Bank 2 / Sensor 1 is in the exhaust manifold or the exhaust pipe before the exhaust enters the catalytic converter
On your 1998 Ford Explorer Sport : The mass air flow sensor is between your engine air filter and the big rubber engine air intake tube
it is possible camshaft position sensor but i am not sure
It's located on the passenger side of the motor, right behind the side motor mount, a little towards the back. You can get to it from the top of the motor.
where the ford symbol is
The door ajar switch is located on the backside of the door latch assembly, and is accessed inside the door by removing the door trim panel.
The intake air temperature sensor is connected to the mass airflow sensor as one unit, it's at the beginning of the air intake tube just after the air cleaner. The sensor with six wires running out of it
Its integrated into the MAF sensor as of 1998.
Bank 1 is the passenger side of the engine in a Ford Explorer Sensor 2 is in the exhaust after the catalytic converter ( downstream )