Want this question answered?
The 1997 Mitsubishi Diamante OBD 2 port is under driver side dash next to center console
Changing the serpentine belt on a 97 Mitsubishi Diamante is a fairly easy task. All you need to do is get a wrench and loosen the tension pulley and pull of the serpentine belt.
the sensor is in the dist
where is located theknock sensor 97 mitssubishi eclipse
There isn't a camshaft position sensor. If you are asking because of an error code you received, it is caused by a signal that mimics the same signal as a camshaft position sensor.
I think it was built in the distributor
P0344 Camshaft Position Sensor Circuit IntermittentP0344 Camshaft Position Sensor Circuit Intermittent
under the distributor cap and rotor button
It is the "pick up" plate in the distributor.
The camshaft position sensor for the 3.0L V-6 engine is located in the distributor. Good Luck!
On the 97 s series trucks with the hvs, The camshaft sensor is located inside of the distributor.
under the water pump.