There is NOT a choke on any fuel injected engine. The coolant temperature sensor does the job of what used to be the choke. When the coolant in the engine is cold, the coolant temperature sensor tells the engine control module and it determines how rich or lean to make the engine run. You can use a scanner to see if it and all the other sensors are doing the job they are meant to perform.
Replace freeze plug in a 1998 ford windstar ?
The fuse box diagram for a 1998 Ford Windstar van is located on the inside cover of the box cover. It can also be viewed within the service manual.
A 1998 Ford Windstar would use refrigerant 134a
According to the 1998 Ford Windstar Owner Guide : If it is equipped with the C/D changer : ( it is located in the center floor console )
It is inside the oil pan on the bottom of the engine block.
on the floor on drivers side, left of brake pedal
There are two catalytic convertors on this model.
there is a button on the end of th gear shift that you simply push in..
it is on the trans,right side you will have to remove cat.converters to access.
On a 1998 Ford Windstar : The 3.8 liter V6 engine ( and the 3.0 ) has a timing CHAIN
On a 1998 Ford Windstar : ( # 16 / 20 amp )
Not likely - the 1999 Windstar was a rather significant updating of design compared to 1995-1998 models.