Want this question answered?
You can't really clean the EGR valve. If it's faulty, it simply needs to be replaced. -Jesse
Plastic headlight covers need to be buffed with rubbing compound used to restore paint
It is not clean able, if bad it needs replaced.
There are sensors at each wheel that reads magnectic impluses. They can be damaged quite easily and should be taken care od and kept clean.
Remove door panel where switch is located. Remove itch. Use fine emery board nd clean points. It worked for me
You could take it off and clean it with carburetor cleaner, but it probably will not help. It will need replaced.
Clean Air Products is located in the city of Minneapolis, which is part of the state of Minnesota. The address for Clean Air Products is 8605 Wyoming Avenue North.
betchel is located in the bathroom, it is a very clean place the end.
Clean Design Brand & Design Agency is located at 8081 Arco Corporate Drive, Suite 100, Raleigh, North Carolina 27617. They are located near Exits 3 and 4A on Interstate 540.
10 quarts and then clean it out
Try removing both battery cables and cleaning them, if the are very dirty soaking them in a solution of water and baking soda will remove most of the corrosion. Clean the terminals on the battery as well.the reconnect both cables and retry. If this doesn't work try charging the battery or boosting it. Good luck
There is no typical PCV valve in these trucks. There is a ventilation tube that is connected to the bottom of the Resonator box that sits on top of the motor. Says "Vortec 4200" on it. When you take the box off to clean the throttle body - yes clean it if you want to correct idle or stumbling when AC is on - you must ensure that it is reconnected along with the fuel Pressure switch vacuum tube.