0
Concentric slave cylinder mounting-1996-99 vehicles equipped with the New Venture Gear transmission.Its mounted in your transmission,but the bleeder screw is assible because theres a hole in transmission,where bleeder is,just put wrench on and loosen,have someone one push clutch pedal to floor and hold,then open valve,do this till air is gone,theres another hole next to hole where bleeder screw is,a metal tube comes out of that one,its the clutch fluid line,good luck.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Where is the bleeder for a hydraulic clutch on a 1998 escort?
The bleeder is located at the clutch arm on the bell housing. There is a fluid line going from the master cylinder to the clutch bleeder. This metal line has flexible hoses at either end. Follow this line down to the front of the engine just about in the middle and you'll find the bleeder valve.
How do you bleed the clutch on a 1998 Mercury Cougar RHD?
Fill resevoir open bleeder valve at slave cylinder Gravity will cause fluid to run out Depress clutch pedal and hold Tighten bleeder screw
Is there any clutch pedal adjustment on a 1998 Chevy S10 and if so how do you adjust it?
the only ajustment is a bleeder valve should be on the left side of the bellhousing
Why is my 1998 GMC sonoma clutch is losing pressure?
The pad on the clutch is getting low
Is there a heater core air bleeder valve on a 1998 s-10 . It has a 2.2 eng. and where is it located?
There is no bleeder valve in the heater system of that vehicle.
Where is the radiator bleeder valve on a 1998 dodge ram 1500?
It doesn't have one.
Where is the line to bleed a clutch in a 1998 kia sportage?
next to stater is where slave cyl. is bleeder is under passanger side
How do you replace air door actuator in gm sonoma 1998?
Where is the blend door actuator on a 1998 Sonoma
Where do you find the clutch slave cylinder on a 1998 Chevrolet Cavalier?
the clutch slave cylinder on this car is located inside the transmission itself. The part has a rubber bushing that separates the the hydraulic lines and bleeder, from the section that is located in the transmission housing itself.
Where is the coolant bleeder valve on a 1998 Pontiac Grand Am?
looks like there is a coolant bleed valve on top of the water pump casting on top of a 2 inch high PC of metal tubing one small needle valve with a 6mm hex nut
How do you bleed a clutch slave cylinder on a 1998 Dodge pickup?
Get clear hose and put on slave cylinder bleeder screw and put other end in glass container,have someone push clutch pedal to floor and hold,then open bleeder screw and watch for air to come out,do this until no more air is seen coming out,make sure the clutch master cylinder has plenty of fluid at all times.Also dont reuse fluid.
How do you change a clutch cable on a 1998 integra?
You don't. There is not a clutch cable on a 1998 integra. It has a hydraulic clutch.
