Where is the code for door lock on a Ford Explorer?
Call the ford dealer and get it
by putting in the code
The factory code is unique to each vehicle
a key...or the clicker? OR The code is on the door lock module that is located just ahead of the jack.
you can lock the driver side door on my 2001 ford explorer sport but it wont unlock with key nor key pad you have to go through passanger door
There's a spring inside the keyless entry pad door lock on 2001 Ford Explorer Sport Where do you connect this spring?
This spring broke inside the driver's door keyless entry pad door lock on my 2001 Ford Explorer Sport. Where do you connect this spring on the door lock?
Lock on driver frot side is not working
I have a 03 ford explorer sport and the key pad code was behind the glovebox on the back of the door lock unlock module
Inside the door, on the back of the door latch/lock assembly.
power door lock actuator is broken and not letting the key raise the lock button
what is the number for the door lock fuse
This can be done with the code on the door. Check in the owner's manual and it will explain how this is done. If you do not have a manual respond that you don't and I will detail mine.
Make sure the door lock is set to the unlocked position, then pull on the door handle.
On my ( 1995 ) Ford Explorer XLT the power door lock relays ( 3 relays ) are in with the tire jack , behind the removable plastic panel on the drivers side of the cargo area . I assume your 2000 would be the same . There are ( 3 ) relays : - all door lock - all door unlock - drivers door unlock
Does it not have a key lock by the front door handle ( that's what I did on my 1995 Ford Explorer XLT when the battery was dead )
If you are referring to your power door lock on the driver's door, I know that on my 1995 Explorer XLT, in the jack storage compartment there are relays for driver door unlock/all door unlock/all door lock/ and two more relays for interior lamps and trailer park lamps.
Assuming that your other doors lock and open properly check the solinoid for the drivers door.
How do you repair the drivers side door lock on your 1998 ford explorer it will not lock even though every thing works?
u will probably need to remove the door card and gain access behind the door handle to remove the lock. Glad to be at assistance
If the lights in your lock buttons remain on after the truck is powered off, you may have a problem with your fuse. It the light remaining on could be because you have an electrical problem in your Ford Explorer, as well.
Your ford explorer 1998 has a switch on the drivers side door that controls both the lock and unlock buttons The switch works for the unlock but not the lock How do you fix it?
The wiring or the locking mechanism may be damaged in your ford explorer. You need to take it to an auto shop to have diagnostic testing done.
Each vehicle has its own keyless entry factory code
the code, if nowhere else, is stored in the computer (PCM). we went to the dealership where they pulled the code with ease. im unaware of the cost, however - our truck was already in for warranty issues, but im sure it wouldn't cost much. hope this helps!
Try turning the ignition on and off about 10 times until the door locks, lock and unlock, then lock with the remote done.
The T-handle or lock mechanism inside the door is damaged.
Cycle the key on/off 8 times and the door locks will lock and then unlock. Press the lock button on your key fob to program it
My ford explorer back hatch open went i start the car and the power lock will not lock with the bottom?
A mechanical problem is causing your Ford Explorer not to lock with the bottom when your start the car.
Usually located behind the driver's door panel. Remove inside door panel for access
You will need a flashlight to see it. Look in the back where the jack is stored and there will be a computer box with the code on it. The jack is located in the back on the driver's side. I think there were 4 tabs to move so you could slide the panel off. I have a 1996 Ford Explorer XLT V8.
I have 93 ford explorer XLT 4 door, can't get in either rear door? I know one door has child lock on drivers side, other side won't open palin and simple. A diagram and or instructions how to fix this problem would be greatly!!! appreciated. Thank you to all out there. I'm Frustrated
How ot unlock a Ford explorer back passenger door that is stuck in the lock position and won't close?
Try holding up on the outside handle and shutting the door. If no luck the door panel must be removed for repair.
On the drivers door armrest has the window lock switch been pressed on the left side ? If it has , then only the drivers door switches operate the power windows . Press the right side of the window lock switch
This information will be in your owners manual. 1. Type in the code you got when you purschased the vehicle 2. After typing in the code press "1" on the keypad 3. Enter in your new code 4. The doors should lock and unlock if this is done correctly. *You can always use the factory code even if you change the code to something else*
Hi, LOCK 13 code can only be unlocked by using suitable electronic equipment,you will have to go to a car radio shop that has this equipment or go to the Ford dealer
Look on the computer box , under dash or in motor compartment.
If there is no obvious damage to the wiring, it is probably the electric motor inside the door. This is a very simple fix on the Explorer so I imagine it is also on the Expedition.
A 2007 Ford Explorer would have 4 wheel ABS ( Anti-lock Brake System )
New lock assembly from junkyard or Ford. I've replaced 3 of these all pulled parts from a junkyard. there are only 3 screws on the inside door panel that need to be taken off, then disassemble the inside parts and pull it out/replace it. A make/model repair manual may help, I got my advice from a Ford Tech.
On a 1998 Ford Explorer , fuse # 18 , 25 amp , is for the drivers unlock relay , all unlock relay , and all lock relay
If you are having trouble with your door locks not working, there is a repair kit available at www.AnyoneCanFixIt.com. The repair is for the door locks when it tries to open but just cannot pop up enough to unlock. If the door lock is not moving, this may not be for you, however, if you can see it bump when you activate it (as if it is trying to open) then the fix at www.AnyoneCanFixIt.com… Read More
Make sure safety lock is totally disengaged-if so door panel will have to be removed to see if any parts are bent or otherwise dislodged and repair accordingly
anti - lock brake system
You can confirm that all your doors etc. are locked on your Explorer by pressing the door lock button on your remote twice in 3 seconds . If the horn chirps once , everything is locked correctly , if it chirps twice , a door , hatch glass , or the liftgate is not properly closed
When you lock the doors and shut the driver door your 2000 ford explorer xlt starts and runs until you push on brake pedal with no key in it help please?
i know what it is its remote start
That means a door is still open or the back glass/gate is open. it will beep once when the doors are closed
How can you fix a power door lock on a 2001 ford explorer sport track. Driver's side unlock still works but lock does not. Must be locked manually.?
Did you find an answer to this problem? I am having the same problem with my 2001 Sport Trac.
If you are having problems with interior door locks on a Ford around that year it is most likely the door lock actuators. There is one on each door. They are very prone to fail on those vehicles. On several occasions I have had to replace every single door actuator on Fords of that age. The actuator is behind the door panel, and fairly easy to access once the panel is off. I don't believe… Read More
1999 ford explorer power door lock switches in left and right front doors won't lock doors will unlock doors the tailgate switch will lock and unlock all doors?
I WOULD LIKE TO KNOW HOW I START MY TRUCK I PUT THE KEYS IN THE INGNTION AND I HAVE TROUBLE STARTING IT I BELIEVE IT HAS SOMETHING TO DO WITH THE SAFETY LOCK
Pull the panel off, might cause damage to panel but is easily replaced. Unlock the yellow tab from the metal door and pull the metal rod attached to it, this will open the door but you need to replace the lock assembly to avoid it in the future.
Your power window lock control on the driver's door has been switched on It is the rocker switch that goes left and right
# Enter the permanent factory remote keyless entry (RKE) keypad code. # Press the 1/2 button within 5 seconds to activate the programming mode. Holding the 1/2 button for more than 2 seconds after activation erases the stored customer code. The door locks lock, then unlock, confirming the code is erased. The existing code does not need to be erased to program a new code. # Within 5 seconds , enter the new 5-digit RKE… Read More