0
What else can I help you with?
Where is the pcm in a 97 Mercury villager?
where is the PCM located on Mercury Villager 97
Where is code reader on Mercury Villager?
The DLC (data link connector) is located under the dash just below the steering column if you have a 1996 or newer Villager. Pre-1996 vehicles have diagnostic connector mounted on the transaxle beside the starter which must be jumpered to obtain the fault codes.
Where is the connector for the obd II scanner cable located on the 2009 mercury mariner?
The OBD-II scanner connector on a 2009 Mercury Mariner is located under the dashboard, near the driver's side. Specifically, you can find it beneath the steering column, typically within a few inches of the driver's seat. It may be necessary to remove a panel or look behind the steering wheel cover to access it.
Where is the event data recorder located on a 1997 mercury villager van?
There is no such device on a '97 villager.
Where is cruise control computer module located at on 1993 mercury villager?
The cruise control computer module is located on the passenger's side of the engine compartment on a 1993 Mercury Villager.
Where is the transmission speed sensor located on a 1998 mercury villager van?
on my 1999 ford mercury villager its on top of transmission under the van
Where is the cruise control module of 1993 Mercury Villager?
The cruise control module of a 1993 Mercury Villager is located under the passenger side of the dashboard.
Where are the spark plugs located in the 2000 Mercury Villager?
In the cylinder head .
Where is the ignition module located on a 1999 Mercury villager?
Inside the distributor
Where is the fuel filter located on a 2001 Mercury Villager?
The filter is located behind the RH side of the carbon canister under the hood.
Where is the OBD2 scanner on a 1999 Mercury Villager Van?
The Data Link Connector (DLC) is located under the dash right under the steering column. Use of a scanner is highly recommended as some engine faults will not activate the check engine light but will be stored as a code in the PCM. On some models, the DLC may be located in the engine compartment beside the starter. (wiring diagram required for ID) Save yourself a lot of guess work and buy a Haynes Repair Manual.
Show where the knock sensor located?
can you tell me where the knock sensor is located on a 3.3l mercury villager
