0
The powertrain control module (PCM) is located in the passengers side kick panel area of the S-10 with the 4.3L engine. If that S-10 has the 2.8L or the 2.5L engine it would have an electronic control module (ECM) also located in the passengers side kick panel area.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the general control module on a type-s?
What does the general control module control
How do you change the Ignition Control Module in a 1995 Blazer S-10?
Remove the wiring harness from your 1995 Chevy Blazer ignition control module. Remove the ignition control module retaining screws. Reverse the process to install your new ignition control module.
How do you replace a 1994 Chevy S-10 blazer transfer case control module?
where is it at
Where is the general control module on a jaguar type-s?
What does the general control module control
Were is the ingition control module on your 1985 Chevy s-10 2.8?
The ign. control module on a 2.8L s10 is in the distributor. Remove the distributor cap and it is attached to the base of the distributor
Where is the ECU in a 1995 S-10?
The PCM (Powertrain Control Module) would be found in the passenger side kick panel area in that 1995 S-10.
Where is the airbag control module located on a 2001 s-10?
I have a 2001 s-10 ext cab with 60-40 front seats. The module was located under the 20% of the drivers seat where a center console would be. It was under the carpet. I had to cut the carpet to get to it. Hope this helps.
Where is the ignition control module located on a 1992 Chevy S-10 Pickup?
The Distributer module on "92" S-10 Vin code "W" or "Z" is located on the distributer,you must remove the distributer cap to gain access to the ignition module. Once you have gained access to the ignition rotor it is always necessary to always test the module before replacing it.
Is the ecu and ecm the same part for a 91 Chevy S-10?
The ecm is the engine control module. I'm not sure what a ecu is.
Where is electroni control module 01 Chevy s 10?
pass side under hood just behind the coolant res. tank!!
How do you change a door control module on Mercedes s class?
unplug it
How do you check ignition control module on 93 s 10?
Diagnosing the ignition control module is done with a diagnostic scope. These scopes can range in cost from a few hundred dollars to several thousand, so the most economic way is to take the car to an auto repair shop.
