answersLogoWhite

0


Best Answer

it goes into your radiator, and then through your cooling system

User Avatar

Wiki User

โˆ™ 2005-11-19 19:10:37
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the coolant going in your 1988 ford ranger?
Write your answer...
Submit
Related questions

Diagram of a fuse box for a 1988 Ford Ranger?

diagram of fusebox on 1988 ford ranger


Water pump for a 1988 Ford Ranger at?

i need help with the temp.gage in a 1988 ford ranger


After driving a burnt smell is coming from the grill area of a Ford Ranger?

Check coolant level Could be alternator going bad Could be coolant fan going bad


How much coolant does a ford ranger radiator hold?

The coolant capacity of the Ford Ranger is dependent on model year and engine type. The latest model year of the Ford Ranger was 2011. The 2011 Ranger with the 4. 0L V6 and the automatic transmission had a coolant service fill of 13. 2 quarts.


What type of oil does a 1988 ford ranger take?

10W30 is the type of oil that a 1988 Ford Ranger takes. The Ford Ranger was first produced in 1983 and discontinued in 2012.


What type of coolant was originally put in a 98 Ford Ranger?

The 1998 Ford Ranger Owner Guide shows Ford Extended Life Engine Coolant ( Dexcool )


How do you replace a broken throttle cable on a 1988 Ford Ranger?

how do i replace a throttle cable on a 1988 ford ranger pickup


What kind of coolant does a 2000 Ford Ranger take?

what type of radiator fluid does a 2000 ford ranger take?


What kind of brakes are on front of 1988 Ford Ranger pickup truck?

fordparts.com shows disc brakes on the front of a 1988 Ford Ranger


Where is the coolant temperature sensor for a 1997 Ford Ranger?

Which engine do you have?


Does a 1988 Ford Ranger have o2 sensors?

I'm not a mechanic / technician but on a 1988 Ford Ranger there might be ( 1 ) oxygen sensor ( upstream sensor )


How do you set the timing belt on a 1984 Ford Ranger 20L?

How do you set the timing on an 1988 ford ranger 4 cylinder


How do you set the timing on a 1991 Ford Ranger after the timing belt breaks?

where to set timing for a 1988 ford ranger 2.2l


How do i repair the slave cylinder on my 1988 Ford Ranger?

The slave cylinder on a 1988 Ranger can not be repaired. The cylinder will have to be replaced, then the system bled.


How much horse power does a Ford Ranger XL 1988 2.9?

I believe the 2.9 liter V6 engine in a 1988 Ford Ranger is rated at : ( 140 horsepower )


What are the causes for no heat problems on a 96 ford ranger?

no heat in 96 ford taraus,new thermostat,has coolant in it


Where is the coolant temperature sensor in a 1994 Ford Ranger 2.3L?

Coolant 'sensor' for EEC purposes is near front coil on heater core hose going to thermostat housing. It's a two wire connector.


Coolant temp sensor location on 2001 ford ranger 2.3l?

yes yes


How much antifreeze to put in 1997 ford ranger?

You should use a gallon of coolant.


V6 2.9L Ford Ranger 1988?

Yes , there was a 2.9 litre V6 engine available in a 1988 Ford Ranger , as well as the 2.0 and 2.3 litre four cylinder engines


Can a 1988 Ford ranger standard transmition work in a 1992 Ford explorer?

I believe they are swithable if the ranger had the 2.9 V-6. (same mounts)


Block coolant drain plug 2000 ford ranger 3.0?

lorftion drain plags 3.0 l Ford


Where is the map sensor located on a 1988 ford ranger 2.9l?

On the engine.


Where is the external fuel pump located on an 1988 ford ranger 4x4 xlt?

The external fuel pump of an 1988 ford ranger 4*4 xlt is located inside the fuel tank or gas tank.


Coolant capacity 2000 ford ranger 3.0 liter?

The 2000 Ford Ranger was equipped with two different 3.0L 6-cylinder options between codes 'U' and 'V' (Flex-Fuel). Both engines have a coolant service fill of 14.8 quarts.