0
Where is the coolant temperature sensor located in a 1988 land rover 110?
Wiki User
∙ 12y ago
I have an 88 110 too, a Saudi Arabian model. Are you located in the states?
The temp sender should be located on the front of the intake manifold (big molded metal thing between the cylinder heads that the carbs are mounted to). The thermostat housing will be in the lower center front of the manifold with two temp sensors leading out but these are not the ones you want. You want the temp sensor that is actually bolted into the manifold on one of the sides. The sensor is most likely be an M16X1.5 threaded sensor with a single electrical lead coming out of it, but you will need to look at your existing sender to be sure.
Also, make sure you have a towel handy and something to plug the hole with so that you don't leak coolant all over your engine bay when you remove the old sensor.
Go to www.d-90.com and look at the VDO installation thread in the forums if you need any more assistance with the sensor swap.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
Where is the crankshaft sensor located in a rover 200?
The crankshaft sensor on a Rover 200 is located below and to the right of the generator and cylinder head temperature sensor. It is on the driver's side of the engine and above the oil filter.
Where is the intake air temperature sensor on a 2002 land rover freelander?
The intake air temperature sensor is under the intake manifold on the 2002 Land Rover Freelander. It is on the top rear section of the engine.
Where is the coolant temperature sensor on rover 200?
There is a brown sensor that screws into a metal pipe on the right hand side of engine bay just behind the radiator, there is a black hose from the radiator that connects to the metal pipe then you will see the sesor screwed in.
Where is the Inlet Air Temperature Sensor located on a 1991 Rover 214 GSI?
The air intake temperature sender is located at the right hand side, back of the engine when looking from the front of the car. It is found screwed into the inlet manifold at the top of the engine. Disconnect wiring and unscrew sensor.
Where do you top up coolant on a rover 25?
Where do i top up my coolant on a rover 25
Where is the speed sensor on rover 200?
where is the speed sensor on a rover 200
Where is the location of crank sensor for range rover v8 4.6HSE MODEL 1999?
The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.
How do you refill coolant on 2003 range rover?
To refill the coolant on a 2003 Range Rover, use the filler tower that is located on the heater hose. Open the valve and pour in the coolant. Run the car for a short time, then top off the coolant after any air in the system has had a chance to be pumped out. Close the valve again to complete the job.
Why does your Radiator fan not turn on rover mg?
Usually ECT or engine coolant temp sensor. That's what tells the engine computer to turn on the fans.
Why does my Rover k series Engine not start when hot?
engine coolent temperature sensor is giving incorrect readings when warm
Where are downstream o2 sensors located?
I am trying to change the bank one downstream oxygen sensor on my 97 land rover dicovery were is it located
Where is the key remote sensor located inside the 2000 Land Rover Discovery II?
It is located under the headllining in the roof between the two sunroofs.
