engine coolent temperature sensor is giving incorrect readings when warm
when the engine is hot the check engine light came on and the fan(is ok) don't start
It could be down to your Canshaft sensor, Which will start when cold and Hot but when you have run for a short time (3 or 4 minutes) Look on this site its very helpful :- http://forums.mg-rover.org/index.php cheers Carl
There is a large screw which goes through the coil pack into the engine block. That screw will get to hot and then cause the engine to stop or not start back when it's hot.
it should start at cold
the two most common no start when hot causes are fuel pump in your fuel tank and loss of spark ignition module
Battery is probly good. If it was bad there would usually be a series of clicks while trying to start. If the engine is is too hot then the computer is not gonna let the vehicle start. If it is not over heating then the coolant temp sensor is probably failing. This is what tells the engine what the the coolant temp is in the engine. Hope this helps some. Of course there are always other factors such as the engine is over heating the starter causing it not to start. Stuff like that. Impossible to say for sure. Just gicing you some things to check. Good luck.
Yes the reason for that is because the engine is over heated and when its cold the engine is nice and cold perfect for starting conditions.
Because the engine gets too hot. Let it cool down before you start it up again. Poor water on it.
If there is no check engine light illuminated, start with the basics like a good tune up.
It is bleeding down---- Leaking fuel out of the fuel bowl and flooding the engine. In other words fowling the spark plugs out. When a engine is cold it needs more fuel to start. But when a engine is hot it needs less fuel to start. You need to make sure the choke plate is opening all the way up when engine is hot and it should stay open until engine cools off. If it is closed when engine is hot that will also flood the engine and it will not start. If choke is working then REBUILD carburetor.
Very literally, hot wire is a wire that is hot. Pertaining to vehicles, to hot wire a vehicle is to start the engine or motor of the vehicles without the use of the ignition.
probably needs the TDC Sensor cleaning.