Where is the cooling fan sensor located on 2000 Grand Cherokee?

It has 2 wires and screws into the housing that the upper hose hooks to.

The coolant temperature sensor on a 2001 Jeep Grand Cherokee is located on the T-stat. It is on the passenger side of the Jeep.

The cam sensor should be located underneathe your distributor cap. That is the placement on my 98 Grand Cherokee and it should be located there as well on yours.

Check the fuse. It is located in the under hood fuse panel.

It does not have a mass airflow sensor.

The 1996 Pontiac Grand Prix cooling fan sensor is located on the front of the engine. The fan sensor can be found just above the thermostat.

The 1994 Jeep Grand Cherokee IAT sensor can be found attached to the air intake hose. The IAT sensor will be near the air filter box.

The governor sensor has to do with transmission fluid pressure.

It is in the distributor.

It is located on the rear of the transmission on the driver's side.

Usually a crankshaft sensor is located on the bellhousing of the transmission

It is in the distributor.

That is the O2 sensor in the exhaust closest to the engine.

It is located at the driver's fender side of the the throttle body.

The speed sensor is located on the drivers side of the transfercase, you will see a sensor with a connector, that is your sensor.

The crank sensor is located on the back of the engine passenger side it bolts to the flywheel backing plate

It goes into the top of bell housing.

Three wire sensor on the throttle body.

If you browse this website you will be able to find what you need: http://www.jeep4x4center.com/mopar/jeep-grand-cherokee/backup-parking-sensor.htm

The TPS is located 180 degrees from your linkages on your throttlebody.

were is the cooling temperature sensor located on my 96 Plymouth grand voyager

The crankshaft position sensor in a 2002 Jeep Grand Cherokee 4.7 liter is located left of the starter. In order to remove the crankshaft position sensor the CKP mounting bolt will have to be removed first.

Inside the distributor. Inside the distributor.

It is inside the transmission, on the passenger side of the valve body.

These fans work off of heat sensors. Your sensor can be failing, replace this sensor. This still does not tell where the sensor is located.

The crank sensor is located on the top of the bell housing on the drivers side.

On my 97 jeep grand Cherokee, with the 5.2 liter v8, its located in the distributor, under cap & rotor.

The oil pressure sensor is screwed into the rear of the oil cooler, under the intake manifold.

On the coolant overflow bottle that in on the passenger side of the engine.

It is on the top passenger side of the bell housing.

on top off the t case

Upper left front view of the radiator.

It is on the top passsenger side of the bell housing.

On the back of the engine, next to the distributor.

Make sure that the fuse and sensor for the cooling fan are working. If these are ok then look at the fan motor, it could be bad.

driver side on the back of the motor where is crak sensor on 94 jeep 4.0 grand Cherokee

The camshaft position sensor is located just above the oil filter on the right side (sitting in the vehicle) of the engine.

The oil pressure sensor is mounted on the rear of the oil cooler under the intake manifold.

The engine coolant temperature sensor is the sensor that is screwed into the thermostat housing on the top front of the engine.

It is located on the back of the block, just to the passenger side of the distributor.

What type of coolant sensor? The below answer is for the coolant LEVEL sensor. The coolant TEMPERATURE sensor on my vehicle is located just next to the thermostat housing. On the front top center area of the engine just behind the radiator. Follow the coolant hoses if you have trouble. On my 1995 Jeep Grand Cherokee the sensor is located on the top of the plastic coolant reservoir tank. Look for a small (2-wire?) electrical…

Its the lock/latch mechanism

Need a special socket. They are located in the exaust manifold(s).

It is under the front of the passenger side cylinder head

Screwed into the engine block very near the oil filter.

O2 sensors are located in manifolds and in the front pipes

on the top of the trans. bell housing right hand side

It is inside the transmission, on the valve body. It is called a range sensor.

There is a sensor located at the bottom of the coolant reservoir.

Your anti freeze collant level sensor if the same as a Chevy impala is mounted under the transmission cooling line on the radiator