If you are referring to the SL 3.1 then they have two Crankshaft Position Sensor's, one is located in the front of the engine at the lower right corner just behind the Harmonic Balancer (which will have to be removed to get the sensor out) and the other one is located on the left side of the engine closer to the front of the engine about half way down just below the plugs. This one is hard to get to. (The front of engine is facing the passenger side of the car)
The Camshaft Position Sensor is located behind the Power Steering Pump.
where is the camshaft position sensor located on a 1999 Oldsmobile intrigue
check main pulley area bottom by harmonic balance
the O2 Sensor Should be on top of your exhaust manifold
Plug has 3 wires.
yes
They are in the exhaust flow
Behind oil filter
The map sensor is located next to the idler air control valve on the front of the motor on top. It has a vaccume hose hooked to it and one bolt holding it on with a bracket.
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine
It is located beneath the power steering pump in the engine block