hi you dont say which engine you have but on the 2.0 tdci fwd the location is at rear of the engine only viewed from underneath nearly at the top of gearbox bellhousing whereit bolts to the engine block you,ll see the wire going to it and the 8mm socket sized retaining bolt you,ll be able to reach at arms length bit awkward but can be done hope this has helped regards aspro
way is my crank sensor over heating on my 2005 colbalt
Locate crank shaft sensor 2005 Chevy aveo
where is the crank sensor located on a 2005 chevy impala
How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?
how do you fix constant reving on a ford transit 2003
Where is the camshaft position sensor on a 2005 Expedition?
It's a recall, dealer will do it for free.
If you are asking about the 2.0L engine....the ECM was changed to what is called a NGC and the crank and tone wheel(pickup for crank position sensor) was changed. Also, the blocks are not interchangeable due to the position of the crank sensor was changed. It may be possible to change the crank and and sensor then extend the harness to reach the front of the engine where it was move from the rear starting in 2003 but this would be alot of work. Everything else on the engine should changeover fine.
It is mounted in a hole in the transmission bell housing right behind the passenger side head and it is hard to see and to get to.
The crank sensor target is on the crankshaft inside the engine on a 5.7L Hemi.
The EGR is not the problem The tone ring on the crank for the crank position sensor is different and the engine will not start.
The throttle position sensor is in the throttle body.