jack up front of car remove left front undercar cover sensor found under crank shaft pully remove connector and measure resisitence of sensor aprox 900 to 1800 ohms
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
It's down behind the starter.
Behind the starter.
behind the crank pully
The (CKP) crankshaft position sensor is located on the front side of the engine block,near the flywheel/driveplate.
where is the crank sensor located on 2000 nissan sentra
scanning for codes will indicate if the CPS is at fault.
timeing cover lower
Crank position sensor, to the right of your oil filter
It is on the top rear of the transmission bell housing.
crank sensor should always be near bottom crank pulley
behind the crank shaft pully and the timing cover and then another pully is there two bolt hold it on