on the engine block , back by the firewall. its hard to see but you can see it from under the car. be careful not to confuse it with the oil psi sending unit. should have a single 8mm nut holding it in the block..
In the back by the coil pack.
Problem with the signal from the Crank Sensor.
its at back of engne just under the manifold
Rear of the engine block.
It is located on the back side of the engine, where the distributor originally went.
On the firewall side of the engine block, near the transmission bellhousing, under the intake manifold that answer sir, is incorrect, the cavaliers did not use a cam sensor, only a crank sensor, but the location is right for the crank sensor
where is the crank sensor located on a 2005 chevy impala
To test a 1995 Cavalier crank sensor you would need to get a mechanic's computer. They can put a sensor/fuse tester on it and see if it is working properly.
The crankshaft position sensor is located behind the starter on the front of the engine. Hope this helps! Mitch art_y2k1@yahoo.com
Bob
it is next to the coils at the rear of the engin between the tranmission and the engin
Chevy did not use a crank sensor on that year.