0
I had a '87 3.8... the 3.8 V6 is much the same for many years, I think this is what you mean?
Anyway, the sensor is on the accessory end of the engine, located just above the large crankshaft pulley at the bottom of the motor. It is not easy to see.
The sensor is held in with one bolt and has two wires coming out of it.
If I recall, the fastening is adjustable for gap between the sensor and crank reluctor.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
Why does your 1988 Buick Regal not start when you try to crank it after it has been running?
if it has a crankshaft sensor that's bad
What would cause a 1988 Buick lasabre to not have spark?
A faulty crank sensor can do that.
Where is the location of the cam sensor in a 1988 Buick Regal with 2.8 engine?
The 2.8 engine doesn't use a cam sensor.
How do you change the head gasket in a 1988 Buick regal?
Procedure to change 1988 Buick regal head gasket
How do you replace a water pump on a 1988 Buick Regal?
no
What causes no spark in a 1988 Buick lasabre?
Crank sensor has failed,Ignition control module (ICM) has failed,Bad ignition coil pack,
Where is the gas pump located on the 1988 Buick Regal?
It's in the fuel tank.
There is no spark on a jeep 1988?
Probably a crank sensor
Why would the throttle stick down on a 1988 Buick Regal?
Lack of lubrication perhaps?
Where is the freon valve located on a 1988 Buick Regal?
Freon valve on my 1989 Buick Regal Custom 3.1 V-6 located on driver side under the area of battery tray. Hope this helps!
Does a 1988 Ford Mustang have a crank shaft position sensor?
I think you mean CAMSHAFT position sensor.
1988 Chevrolet 1500 350 cranck shaft poitioner sensor?
Gm. did not use a crank shaft sensor in 1988, It had a distributor that done everything.
