answersLogoWhite

0


Best Answer

It is on the top rear of the transmission bell housing.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the crank sensor on a 1999 Chrysler Sebring convertible jxi v6 2.5l?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the Crank Sensor on a 1998 Chrysler Sebring convertible 2.5L?

It is on the top rear of the transmission bell housing.


What is the meaning of the P1391 code 98 Chrysler sebring convertible?

1391 is for an intermittent loss of the cam sensor or crank sensor signal


Where is crank sensor located on 97 sebring lxi?

where is the crank sensor located on my 1997 Chrysler sebring lxi


Where is the crank sensor on a 1996 Chrysler Sebring 2.5?

It is on the top rear of the transmission bell housing.


Why would there be no spark or no fuel getting to engine on 1997 Chrysler sebring?

Possibly the crank sensor or the coil pack is dead. But with a dead crank sensor you also get no spark, no crank. No crank equals no fuel delivery.


Where is the crank sensor located in a 2002 Chrysler Sebring LX?

is your car is a v6 2.7 it will be on the trans mission by the EGR


What are the symptoms when a crank sensor is bad in a 1996 Chrysler Sebring?

The most common would be engine cranks but does not start.


On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?

There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.


Where is the crank position sensor on a 2000 Chrysler sebring 2.5 v-6?

It is on the top rear of the transmission bell housing.


Where is the crank sensor located on 1996 Sebring convertible 2.5 motor?

It's in the top of bell housing of the transmission near the back of the engine compartment.


Why would a 1997 Chrysler Sebring run fine and then just die?

Out of gas, fuel pump, cam sensor, crank sensor, coil, computer, alternator, etc.


Are the cam position sensor and crankshaft sensor the same thing in a 1999 sebring convertible v6?

No, the crank sensor reads crankshaft speed. The cam sensor reads camshaft speed. The cam sensor is on the distributor on a 1999 2.5L