0
Where is the crank sensor located on 1996 Sebring convertible 2.5 motor?
Wiki User
∙ 11y ago
It's in the top of bell housing of the transmission near the back of the engine compartment.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
Where is crank sensor located on 97 sebring lxi?
where is the crank sensor located on my 1997 Chrysler sebring lxi
Where is the Crank Sensor on a 1998 Chrysler Sebring convertible 2.5L?
It is on the top rear of the transmission bell housing.
What is the meaning of the P1391 code 98 Chrysler sebring convertible?
1391 is for an intermittent loss of the cam sensor or crank sensor signal
Where is the crank sensor on a 1999 Chrysler Sebring convertible jxi v6 2.5l?
It is on the top rear of the transmission bell housing.
Where is the crank sensor on 2004 sebring 2.4l?
The crank sensor is located under the car near the exhuast. If you have the replacement you'll see it easy.
Are the cam position sensor and crankshaft sensor the same thing in a 1999 sebring convertible v6?
No, the crank sensor reads crankshaft speed. The cam sensor reads camshaft speed. The cam sensor is on the distributor on a 1999 2.5L
Where is the crank sensor located in a 2002 Chrysler Sebring LX?
is your car is a v6 2.7 it will be on the trans mission by the EGR
I have multiple misfire codes on my Chrysler sebring and now my car doesn't run?
Replace the crank sensor located on bell housing of trans.
Where is the crank sensor located on 1998 Bravada?
the crank sensor is located just behind the crank shaft pully of the engine.
Where is the crank shaft sensor in a 1997 sebring convertable?
crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.
Why would there be no spark or no fuel getting to engine on 1997 Chrysler sebring?
Possibly the crank sensor or the coil pack is dead. But with a dead crank sensor you also get no spark, no crank. No crank equals no fuel delivery.
On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
