answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: Where is the crank shaft sensor on 2003 Kia Sedona?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the crank shaft sensor on a 2003 fiesta?

Engine type ??????????


Were is the crank shaft position sensor on a 2002 Kia rio?

where is the crank position sensor located on 2003 kia Rio 1.8


Where is the crankshaft sensor on a 2003 Kia Sorento?

unfortunately the sensor is behind the plastic cover on the front of the engine and just above the crank shaft


Where is a crank shaft positioning sensor located in a 2003 altima?

It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.


Where is the crank sensor on 2003 grand am?

where is crank senser located on 2003 pontiac


Is the crank sensor on a 3.5 2003 Nissan altima located inside the oil pan?

no it;s behind the timing belt near the front timing gear o on the crank shaft


Where is the crankcase sensor located on a 2003 pt cruiser turbo?

It does not have a crank case sensor.It does not have a crank case sensor.


Where is the crank position sensor for a 95 blazer?

Where is the crank position sensor hole on a 2003 Blazer


Where is the knock sensor on a Kia Sedona?

where is the knock sensor on 2003 kia Sedona answer knock sensor is mounted on the engine block near the intake manifold with a wiring harness attached to it.


Replace crank shaft sensor on a 2003 liberty jeep?

it sould be on the left side of the motor if your looking at the car on the side of the block under the manifold drive safe


Where is the 2003 Kia Sedona fuel temperature sensor located?

in the gas tank


Is the cam shaft sensor the same as the crank shaft sensor on a 2003 silverado 1500 5.3?

NO. The crankshaft sensor is mounted in the side of the engine block behind the starter. You will have to remove the starter to get to it. The cam sensor is bolted to the top right side rear corner of the intake manifold. It is tucked in under the intake just alittle and it is hard to see.