answersLogoWhite

0


Best Answer

On a 2000 Oldsmobile Intrigue with a 3.5L engine it is behind the starter at the front of the car. .

I had to replace the Crankshaft position Sensor on my 99 GL with 3.5L. It was on the backside of the block directly above the starter. To get to it, I unbolted the starter from the transmission and dropped it down a few inches. The Crank sensor is mounted to the block with a single small bolt that is hard to get at, but you can see it. You'll need a fairly flat socket or wrench to work it loose as there isn't much room.

On a 2001 with the 3.5L it is located on the front of the engine, more to the drivers side than the passenger side. You will need a 15 mm socket and an 8 inch extension for the starter bolts. You will need a 10 mm wrench for the plastic shroud which helps support the starter, and also the sensor bolt uses the 10mm wrench as well. I found it easier to slide feet first under the properly supported car to do the work. The higher you can get the car, more arm room you will have as the sensor is in a kind of awkward space.

User Avatar

Wiki User

โˆ™ 2015-07-17 17:42:35
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the crank shaft sensor on a 1999 Oldsmobile Intrigue?
Write your answer...
Submit
Related questions

Where is the crank shaft position sensor on a 1999 Oldsmobile intrigue 3500 engine?

The crank shaft positioning sensor is behind the starter. A real bear to get to.


How do you change the crank shaft position sensor on an Oldsmobile Intrigue?

For 3.5l, remove starter.


2002 Oldsmobile intrigue hard to start and stalls occasionally?

Its either your cam shaft position sensor or the crank sensor.


Where is the crank shaft sensor on a 2000 Oldsmobile intregue?

under the starter


Where is the crank sensor located on a 2004 Oldsmobile alero 4 cylinder?

The crank shaft position sensor is just above the oil filter at the tail end of the starter


Where is the crank shaft sensor located in a Audi a4?

Where is the crank shaft sensor located in a Audi a6


How do you know if your crank shaft sensor is bad?

One symptom of a bad crank shaft sensor is the car having trouble starting. The car stalling and backfiring are other symptoms of a bad crank shaft sensor.


Where is the Crank Sensor in a 2001 Malibu?

The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.


Where is the crank shaft sensor on a 1995 Oldsmobile Achieva 4 cylinder?

well on the 6 cylinder, it is behind the crankshaft pully, try there.


Where is the accelerator sensor located on 2000 Oldsmobile Intrigue?

It is called a Throttle Position Sensor (TPS), and is located on the throttle body butterfly cross shaft opposite the throttle cable cam.


What is the Location of crank shaft sensor 1992 Chevy truck?

That year model does not have a crank sensor.


Where is the crank sensor located on 1998 Bravada?

the crank sensor is located just behind the crank shaft pully of the engine.


Where is the crank shaft sensor on a 2000 suburban?

The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.


Is the crank shaft sensor part of a tuneup?

No


Where is the crank shaft sensor in a 1997 sebring convertable?

crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.


What makes the crankshaft position sensor go bad?

what can make a crank shaft sensor keep goin bad even if its been replaced 4 times.. in a 2000 oldsmobile bravada


Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?

Chevy did not use a crank sensor on that year.


Where do you find the crank shaft position sensor on a 1996 Nissan altima?

Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..


Where is the location of crank sensor for range rover v8 4.6HSE MODEL 1999?

The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.


Where exactly is the 2000 Chevy Impala crank shaft sensor?

install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft


Can a crank shaft sensor leak oil?

Yes, if it is a sensor that goes into the block.


Location of crankshaft sensor in 1997 GM suburban?

It does not have a crank shaft sensor.


Diagram of a crank position sensor in a 2002 Nissan Frontier?

location of a crank shaft sensor on a nissan frontier 2002


I have a Buick la Sabre that wont turn over?

Crank shaft sensor need replaced or cam shaft sensor


Why does your 1996 Lincoln mark VIII have no spark?

ck cam shaft sensor, check crank shaft sensor also.