Car Computers and Sensors
Oldsmobile Intrigue
Crankshaft Sensors
Late Model 1979-New Ford Mustangs

Where is the crank shaft position sensor on a 1999 Oldsmobile intrigue 3500 engine?

232425

Top Answer
User Avatar
Wiki User
Answered
2005-11-05 18:39:15
2005-11-05 18:39:15

The crank shaft positioning sensor is behind the starter. A real bear to get to.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


where is the camshaft position sensor located on a 1999 Oldsmobile intrigue

where is the crank sensor located on a 2002 Oldsmobile intrigue 3.5

Its either your cam shaft position sensor or the crank sensor.

I have a 98 olds intrigue...the camshaft position sensor is located around the middle polley on the left side of the engine. It has one screw. It's fairly easy to install.

The 1998 Oldsmobile Intrigue throttle position sensor is held in place with two retaining screws. Remove the retaining screws and the wiring harness. Reverse the process to install the new throttle position sensor.

Can you show me a diagram of the upstream oxygen sensor on a 3.5l liter Oldsmobile Intrigue engine?

depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.

Never heard of an "ignition sensor". Do you mean oxygen sensor, or maybe crank position sensor, or cam position sensor? There is an ignition "module" also... The oxygen sensor is on the exhaust manifold. The crank posiiton sensor is on the backside of the block. The cam position is on each head.

The crankshaft sensor is in the front of the engine.Above the starter.You will have to drop the starter.2 15mm bolts.Look up and there it will be.

The ETC sensor on the 2002 Olds 3.5 engine is located at the right rear of engine, below the throttle body at the head not the block.

It is called a Throttle Position Sensor (TPS), and is located on the throttle body butterfly cross shaft opposite the throttle cable cam.

Is this a 3.5L Intrigue V6 engine? If so, it should be behind the left exhaust manifold. You will need to remove the starter to gain access.

where is the crank sensor located at on a 1996 cutlass ciera wit a 3.1 engine

show location of camshaft position sensor for 2002 Oldsmobile bravada.

I have Olds Intrigue 2000 3.5L. Needed to replace faulty crankshaft sensor.3.5L engine has two of them. If engine is hard to start cold or hot and engine light is OK.Very common problem for this engine in Aurora 3.5 and Intrigue 3.5 is crankshaft position sensor. Which is located above and behind starter. Starter must be removed first.------------------------------------------------------------------------------------------------------------AnswerLower right hand side of the engine just above the oil pan. Theres a single bolt that holds it in.

looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.

It is located above the starter. you must remove the starter for access. Make sure you disconnect the battery first.

On the 99 Olds Intrigue, the camshaft sensor is located on the rear of the engine. It is just above the starter.

The oxygen sensor on a 1999 Oldsmobile Intrigue 3.3 liter is in the exhaust manifold/pipes

The camshaft sensor on the 99 Olds Intrigue is located on the engine block. It is under the starter, which has to be removed to locate the camshaft sensor.

1st o2 senor is between exhaust. 2nd o2 sensor is under shifter

It is located beneath the power steering pump in the engine block


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.