To the right of the crank shaft pulley. You should see a single black wire going up from the pulley. All you need is a 10MM socket to remove it.
In mass air flow sensor.
It is located on the inside of the distributor . Three pin connector .
What are the head bolt torque specs for a mazda mx3 1600
try HEI mod it should work http://www.mx-3.com/phpBB3/viewtopic.php?f=15&p=461052
Check for cracks in the air line before the Mass air flow sensor. If they get too much air the computer shuts it off. Could be crank angle sensor as well but I would place money on it being the air intake.
The Mazda MX3 was first produced in 1991. It was introduced at the Geneva Motor Show in March of 1991. The MX3 was produced until 1998, when production was halted.
Necessity speedometer sensor que va en el panel de instrument cluster vin jm1ec4313p0212457 mazda mx-3, 1.6l , 4 cylinder's, automatic ano 1993
it is located on the mass air flow censor on the intake. it is connected right on the out side of it.It has 5 wires running to it.
yes, you will have to remove all the plastics from the 94 and put them into the 92, as well as the wiring.
the throttle position sensor should be on the side or the bottom of the throttle body. it is a little black or silver piece with 2 screws on it
well...there is no fan belt on any model of mx3, its using an electrical fan, and if you have A/C it has a second electrical fan just beside it. If its not working, it could be the relay, the motor, or the coolant sensor
Between the throttle body and the Air box (air filter) Its the only metal piece on the hose between the two.