the throttle position sensor should be on the side or the bottom of the throttle body. it is a little black or silver piece with 2 screws on it
To change a throttle position sensor on a 1998 Bravada, disconnect the negative battery cable. Separate the wiring harness connector on the throttle position sensor and take off the sensor. Replace with new.?æ?æ
The throttle position sensor determines the amount of throttle used when the engine is running at various speeds. If the sensor is faulty, it can be replaced by ordering a new part.
"how do you change a throttle position sensor on a 1998 jeep grand Cherokee?" could someone without any experience do it?
My f-250 is bogging out when I give it any throttle I thought that it may be either the throttle position sensor or the air sensor that is located on the side of the throttle body?
The throttle position sensor is in the throttle body.
The function of a throttle position sensor is to monitor the position of the throttle in an internal combustion engine.
i found it easier to remove the throttle body to access the tps sensor. the screws can be somewhat difficult to loosen due to corrosion and position of the sensor.
The throttle position sensor is located on the throttle body at the end of the throttle shaft.
The throttle position sensor is located on the throttle plate.
The throttle position sensor is on the throttle body.
The throttle position sensor is on the throttle body, opposite of where the cables attach.
Generally speaking the throttle position sensor is on the throttle body.