i found it easier to remove the throttle body to access the tps sensor. the screws can be somewhat difficult to loosen due to corrosion and position of the sensor.
Check the throttle position sensor
location of throttle position sensor
There is a problem with the throttle posistion sensor
i think, but don't hold me to this, on the driverside just below the air filter box. postioned to the torqconverter case next to the tranny. u can see a throttle cable attached to this position sensor if i am not mistaking this to a taurus...
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
typically they are located on the air intake connected at the throttle body
the crank position sensor sends info to the ecu for position of the crankshaft in order to fire the correct amount of fuel and when to send the spark to the sparking pulg.the engine will not start.you can find the sensor mid engine near the crank.
Right where the engine and tranny are bolted together
Where is the coolant temperature sensor on a 2001 ford focus?" Where is the coolant temperature sensor on a 2001 ford focus Where is the coolant temperature sensor on a 2002 ford focus
On a single cam ford focus 2000-2001 the cam position sensor is below the pcv valve. If looking at the engine it is on the right side, rear, about a 3inches from the top of the engine.
to hold the lens in its position and change the focus of the lens
Change CHT sensor=Cylinder Heat Termo switch
The crankshaft position sensor is behind the catalytic converter, in the area where the engine mates to the transaxle. Access is from below, and you should wait for it to cool down. This answer is specific to the DOHC 2.0L Zetec engine.
Where is the temp sensor on 2000 ford focus zetec engine
the trs is on top of trans.the shift cable is on top of it.remove cable then unplug and remove bolts.try to get back in same position or it will not work rite
A "parfocal" microscope maintains its position as objectives are changed.
Using a Digital Multimeter set to 2k,..the resistance should be 200 to 900 ohms ifnot replace,
the crank potion sensor is located under the front end of the car directly in front of the transmission. Actually when you look at it, it almost looks like it goes in to the trans.
unplug from loom, get big spanner and unscrew from exhaust. refit in reverse
401 sensor on 2001 ford focus
The computer turns that light on to tell you that a fault has been detected and the fault code has been stored. Use an automotive code scanner to determine what's wrong. If it's still running well, I'd suspect something like the oxygen sensor, throttle position sensor or any of a number of potential problems. The computer WILL tell you, you just need to know how to ask.
The 2001 Ford Focus transmission range sensor is located on the side of the transmission. The sensor will be on the left-hand side of the transmission.
with the maf sensor
You can find the diagram of the throttle body on a 2000 Ford Focus with 2.0 SPI at various auto part stores. You can also check in the owner's manual.