answersLogoWhite

0


Best Answer

the crankshaft sensort is at bottom under the distrbutor it is way down there by the trans housing.

User Avatar

Wiki User

โˆ™ 2007-02-02 19:17:57
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar
Study guides
๐Ÿ““
See all Study Guides
โœ๏ธ
Create a Study Guide

Add your answer:

Earn +20 pts
Q: Where is the crank shaft sensor on a 98 Chrysler Cirrus?
Write your answer...
Submit
Related questions

How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?

How do you replace crank shaft sensor on 2005 Chrysler 2005 300c?


Would the crank shaft sensor stop the 1996 Chrysler van from turning over?

No.


How many crank shaft sensors does a 2006 Chrysler 300 have?

On crankshaft position sensor, one camshaft position sensor.


On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?

There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.


Where is the crank shaft sensor located in a Audi a4?

Where is the crank shaft sensor located in a Audi a6


How do you know if your crank shaft sensor is bad?

One symptom of a bad crank shaft sensor is the car having trouble starting. The car stalling and backfiring are other symptoms of a bad crank shaft sensor.


Where is the Crank Sensor in a 2001 Malibu?

The crank sensor on a 2001 Malibu is located on the bottom of the engine near the crank shaft. It monitors the rotation and speed of the crank shaft.


Where is the crank shaft sensor in a 1994 3.5 liter chrysler?

It is on the passenger side of the transmission bell housing, behind the engine.


Where is the crank shaft sensor located on a 2000 Chrysler 300m?

Just behind the engine, in the passenger side of the bell housing.


Where is the cam shaft sensor in a Chrysler cirrus 1999?

Driver side of the cylinder head on the four cylinder Inside the distributor on the V6.


What is the Location of crank shaft sensor 1992 Chevy truck?

That year model does not have a crank sensor.


Where is the crank sensor located on 1998 Bravada?

the crank sensor is located just behind the crank shaft pully of the engine.


Where is the crank shaft sensor on a 2000 suburban?

The crank shaft sensor on a 2000 Chevy Suburban is located on the bottom of the engine, near the oil filter. It constantly monitors the crank shaft and updates the vehicle's computer of its status.


Where is the crank shaft position sensor on a 1999 Oldsmobile intrigue 3500 engine?

The crank shaft positioning sensor is behind the starter. A real bear to get to.


Would the crank shaft sensor on a 1999 Chrysler Sebring prevent the car from starting?

Yes, it could along with dozens of other possibilities.


Is the crank shaft sensor part of a tuneup?

No


Where is the crank shaft sensor in a 1997 sebring convertable?

crank shaft sensor is near the oil filter. I have the repair manual but I am unable to past the page in here.


Where is the crank shaft sensor for a 1989 Chevy van 4.3 liter?

Chevy did not use a crank sensor on that year.


Where do you find the crank shaft position sensor on a 1996 Nissan altima?

Follow the front wire on the distributor and it will lead to the crank shaft position sensor. hope this helps..


Where is the location of crank sensor for range rover v8 4.6HSE MODEL 1999?

The 1999 Range Rover 4.6 liter engine crank shaft sensor is located on the back of the engine. The crank shaft sensor is behind the rear engine cover.


Where exactly is the 2000 Chevy Impala crank shaft sensor?

install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft


Can a crank shaft sensor leak oil?

Yes, if it is a sensor that goes into the block.


Location of crankshaft sensor in 1997 GM suburban?

It does not have a crank shaft sensor.


Diagram of a crank position sensor in a 2002 Nissan Frontier?

location of a crank shaft sensor on a nissan frontier 2002


I have a Buick la Sabre that wont turn over?

Crank shaft sensor need replaced or cam shaft sensor