0
Where is the crankshaft position sensor located on a 2002 impala 3.8L engine?
Wiki User
∙ 9y ago
It is located behind the crankshaft harmonic balancer pulley on the bottom front of the engine. The right lower splash shield and harmonic balancer pulley must be removed to replace it.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor located for 2005 impala?
Most likely in the Rear of the engine or on the side.
Where is the crankshaft sensor located in a 2001 Chevy Impala LS?
crankshaft sensor is located just behind the crankshaft pulley on the front of the engine(passenger side of vehicle).
Where is the throttle position sensor located on a 2002 Chevy impala?
The 2002 Chevy Impala throttle position sensor can be found on the top of the engine. The throttle position sensor will be near the injector fuel pump.
Where is the oil filter located on a 1960 Chevrolet Impala 6 cylinder engine located?
were is the oil filter located on a 1960 Chevrolet impala 6 cylinder engine located
Where is the crankshaft sensor located in a 2007 Chevy Impala LS?
impala cranking but not starting; replaced fuses, relays, fuel pump and igntion coils.
Why does your 2001 Chevy Impala engine shut down on occasion just like it is out of gas even though it is almost full and then after you wait for a short time it starts right up and may be fine for an?
I had a similar problem, and it turned out to be the Crankshaft Position Sensor (located behind the harmonic balancer). It would short out and cause the engine to stall.
Where is the gas filter located on 2005 impala?
under the engine to the left
Where is oil filter located on the 2010 Chevy Impala 3500 V6 engine?
Under the engine.
Where is the thermostat is located on a 2000 Impala LS?
It is located at the engine end of the top radiator hose.
Is there two crankshaft sensor for 2001 Chevy Impala?
According to auto stores there are two crankshaft sensors. One is behind the crankshaft and I'm not sure where the other one is located. Having the same problem with the second one that has 2 prongs.
Does the computer need to re programed after changing the crankshaft position sensor on a 2000 3.8 impala LS?
AFAIK no, you just need to do the crankshaft variation learn. If you don't have a scan tool with the required functionality, you will have to visit a mechanic.
Where is engine coolant temperature sensor P0118 located on 1996 Impala SS LT 1 engine?
It is located in the water pump housing on the front of the engine
