Answerthe camshaft sensor is the distributor but the crankshaft position sensor is located right next to the crankshaft its held on by one bolt
The crank position sensor is located on the front of the engine, behind the lower crank pulleys.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
The bank 2 is located on the driver side of the engine on the Mazda Tribute. The Sensor 2 is located after the catalytic converter.
No.
On most 90s Mazdas the firing is controlled by the crankshaft position sensor that sends a signal to the ignition coil telling it when to spark, on v6 models the sensor is located underneath and to the right of the crankshaft pulley on the passenger side of the car.
It depends of the year some have the sensor inside the ignition and others have it at the crankshaft pullie
The 2003 Mazda camshaft position in sensor can be found on the back of the left-hand cylinder head. The camshaft position sensor should be labeled as such.
The camshaft position sensor on a Mazda Miata is changed by disconnecting the wiring harness and unscrewing the sensor using a wrench. The threads can then be cleaned and a new sensor torqued into place.
The airbag light on a 2003 Mazda Tribute will stay on if a defect is detected in the system. This can include the sensor or the airbag itself which should be immediately repaired.
It is behind the Timing Cover. Torwards the crank pulley.
The throttle position sensor is on the throttle body.