The crankshaft position sensor is located behind the cam gears. you have to remove the timing belt to get to it. If your not having any problems don't fool with it. This is actually the camshaft sensor, the crankshaft sensor is down near the crankshaft and is the wire that runs up over the timing belt inside cover. It is very hard to reach and not many diagrams on it.
On the Daewoo Leganza it is located behind the AC compressor.
The camshaft position sensor is located in the engine compartment of the 2002 Daewoo Leganza. It is at the end of the camshaft housing.
In the air tube just after air filter.
Located behind the A/C Compressor. You will need to remove the P/S Pump, A/C Compressor then the bracket that holds them both.
Here is a link for a parts place. http://www.partsamerica.com/ProductList.aspx?parttype=985&ptset=A&searchfor=Cam+Position+Sensor
Pull aff ac bracket and the wire will lead you there
Where is the crankshaft sensor on daewoo cielo glx 1996 dohc.
behind the cam gears.underneath the valve cover.
Hope this will help it happend to me. It was my cam sensor and the dealer fixed it for free.
when you open your hood and you look on the valve cover you see on your left side of top of your cover a cable sticking out from a black piece that is the positioning sensor that cranksup the car.
Under the timing belt cover, sensor runs of tooth wheel on timing belt crank cog. job and a half.
Where is a crankshaft sensor located on a nissan almera 2001
P1780 Push - Pull Sensor Mal, could you please explain what the push - pull sensor is please?
cmp snsr will not prevent the car from starting,ckp snsr would.
The camshaft position sensor is located on the end of the camshaft housing, on a 2002 Daewoo. The sensor should be labeled as such.
where is the crankshaft sensor located on a 1988 cutlass supreme
The sensor in the distributor is the crankshaft position sensor.
take spark plug cover off you see 4 plugs its next to the 1st plug on your left a wee black box camshaft sensor
Where is the crankshaft sensor located
The crankshaft position sensor is located behind the timing cover and above the crankshaft gear. the timing belt my have to be removed to access the bolts on the sensor.
The 1994 Ford F1 50 crankshaft sensor is located on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft sensor.
crankshaft sensor is located just behind the crankshaft pulley on the front of the engine(passenger side of vehicle).
On 01 Daewoo lanos 1.6l USA, the crankshaft position sensor it location on passenger side under car to the rear of a round gear called the crankshaft.it will be very close to this gear but will not be touch it as it uses the "Hall Effect" to detect the position of the crankshaft. This sensor should be location in the same location of all year models of lanos 99-02
how to replace the crankshaft position sensor located in a 2003 kia rio
Where is the crankshaft position sensor located on Audi 2002 Audi TT